enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Engine knocking - Wikipedia

    en.wikipedia.org/wiki/Engine_knocking

    In spark-ignition internal combustion engines, knocking (also knock, detonation, spark knock, pinging or pinking) occurs when combustion of some of the air/fuel mixture in the cylinder does not result from propagation of the flame front ignited by the spark plug, but when one or more pockets of air/fuel mixture explode outside the envelope of the normal combustion front.

  3. Ignition timing - Wikipedia

    en.wikipedia.org/wiki/Ignition_timing

    Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.

  4. Pre-ignition - Wikipedia

    en.wikipedia.org/wiki/Pre-ignition

    The reduced engine speeds allow more time for autoignition chemistry to complete thus promoting the possibility of pre-ignition and so called "mega-knock". Under these circumstances, there is still significant debate as to the sources of the pre-ignition event. [3] Pre-ignition and engine knock both sharply increase combustion chamber temperatures.

  5. Diesel engine runaway - Wikipedia

    en.wikipedia.org/wiki/Diesel_engine_runaway

    Diesel engine runaway is an occurrence in diesel engines, in which the engine draws extra fuel from an unintended source and overspeeds at higher and higher RPM, producing up to ten times the engine's rated output until destroyed by mechanical failure or bearing seizure due to a lack of lubrication. [1]

  6. Exhaust gas recirculation - Wikipedia

    en.wikipedia.org/wiki/Exhaust_gas_recirculation

    In a typical automotive spark-ignited (SI) engine, 5% to 15% of the exhaust gas is routed back to the intake as EGR. The maximum quantity is limited by the need of the mixture to sustain a continuous flame front during the combustion event; excessive EGR in poorly set up applications can cause misfires and partial burns.

  7. Internal combustion engine - Wikipedia

    en.wikipedia.org/wiki/Internal_combustion_engine

    Cooling is required to remove excessive heat—high temperature can cause engine failure, usually from wear (due to high-temperature-induced failure of lubrication), cracking or warping. Two most common forms of engine cooling are air-cooled and water-cooled. Most modern automotive engines are both water and air-cooled, as the water/liquid ...

  8. Misfire - Wikipedia

    en.wikipedia.org/wiki/Misfire

    An engine misfire, see engine knocking A song on Queen's album Sheer Heart Attack A malfunctioned cartridge that fails to discharge at all ( dud ), doesn't discharge promptly ( hang fire ), or only partially discharges ( squib load ) when being shot from a firearm.

  9. Flooded engine - Wikipedia

    en.wikipedia.org/wiki/Flooded_engine

    A flooded engine is an internal combustion engine that has been fed an excessively rich air-fuel mixture that cannot be ignited. [1] This is caused by the mixture exceeding the upper explosive limit for the particular fuel. An engine in this condition will not start until the excessively rich mixture has been cleared. [2]