Search results
Results from the WOW.Com Content Network
The test is typically performed over a range of test voltages from 0.5 Uo to 2 Uo depending on the standard/guide that is being followed. Apply VLF in order to detect and measure partial discharge . In this case, the IEEE 400.3 outlines a procedure for assessment and IEC 60270 provides the background for partial discharge testing of high ...
IEC 60169 Radio frequency connectors; IEC 60172 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires; IEC 60183 Guidance for the selection of high-voltage A.C. cable systems; IEC 60188 High-pressure mercury vapour lamps – Performance specifications
The tester has output overload protection. The test voltage may be either direct current or alternating current at power frequency or other frequency, like resonant frequency (30 to 300 Hz determined by load) or VLF (0.01 Hz to 0.1 Hz), when convenient. The maximum voltage is given in the test standard for the particular product.
Variations in the electrical conductivity and magnetic permeability of the test object, and the presence of defects causes a change in eddy current and a corresponding change in phase and amplitude that can be detected by measuring the impedance changes in the coil, which is a telltale sign of the presence of defects. [5]
CISPR is the acronym of Comité International Spécial des Perturbations Radio, [1] or the International Special Committee for Radio Protection of IEC. CISPR Standards aim to the protection of radio reception in the range 9 kHz to 400 GHz from interference caused by operation of electrical or electronic appliances and systems in the electromagnetic environment.
The connector reliably carries signals at frequencies up to 100 MHz. [1] The coupling shell has a 5 / 8 inch 24 tpi UNEF standard thread. [4] The most popular cable plug and corresponding chassis-mount socket carry the old Signal Corps labels PL-259 (plug #259) and SO-239 (socket #239). [12]
The content could be general descriptive information, information on wiring and connections, test procedures, or piece-part replacement and repair information. The BSP documents were produced in primarily two formats, 8 1/2"x11" pages for use in office environments, and in a small, portable format (4" x 6 7/8") for use by installers on the job ...
A mock-up of a TPS report cover sheet, created for the movie Office Space. A TPS report ("test procedure specification") is a document used by a quality assurance group or individual, particularly in software engineering, that describes the testing procedures and the testing process.