Search results
Results from the WOW.Com Content Network
The test is typically performed over a range of test voltages from 0.5 Uo to 2 Uo depending on the standard/guide that is being followed. Apply VLF in order to detect and measure partial discharge . In this case, the IEEE 400.3 outlines a procedure for assessment and IEC 60270 provides the background for partial discharge testing of high ...
IEC 60169 Radio frequency connectors; IEC 60172 Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires; IEC 60183 Guidance for the selection of high-voltage A.C. cable systems; IEC 60188 High-pressure mercury vapour lamps – Performance specifications
The significance of each category or class is the limit values of which the Pass/Fail and frequency ranges are measured: Cat 3 and Class C (no longer used) test and define communication with 16 MHz bandwidth, Cat 5e and Class D with 100 MHz bandwidth, Cat 6 and Class E up to 250 MHz, Cat6A and Class EA up to 500 MHz, Cat7 and Class F up to 600 ...
The tester has output overload protection. The test voltage may be either direct current or alternating current at power frequency or other frequency, like resonant frequency (30 to 300 Hz determined by load) or VLF (0.01 Hz to 0.1 Hz), when convenient. The maximum voltage is given in the test standard for the particular product.
General requirements and test methods; EN 438: Decorative high-pressure laminates (HPL) sheets based on thermosetting resins. EN 440: "Welding consumables wire electrodes and deposits for gas shielded metal arc welding of non-alloy and fine grain steel - Classification" (1994) EN 450: Fly ash for concrete - Definitions, requirements and quality ...
The content could be general descriptive information, information on wiring and connections, test procedures, or piece-part replacement and repair information. The BSP documents were produced in primarily two formats, 8 1/2"x11" pages for use in office environments, and in a small, portable format (4" x 6 7/8") for use by installers on the job ...
Variations in the electrical conductivity and magnetic permeability of the test object, and the presence of defects causes a change in eddy current and a corresponding change in phase and amplitude that can be detected by measuring the impedance changes in the coil, which is a telltale sign of the presence of defects. [5]
It applies to power, communications and fibre optic cables irrespective of the place of manufacture. These tests with a few exceptions need to be carried out by an independent Notified Body. BASEC is designated Notified Body No. 2662 for the CPR System 1+ and System 3. BASEC has the fire test equipment to undertake the following tests: