Ads
related to: marine transmission oil coolers
Search results
Results from the WOW.Com Content Network
Maintenance of marine heat exchangers is important to ensure the small pathways in both types of coolers do not become fouled. Depending on the system different types fouling may occur. In oil based systems, an insufficient amount of cooling medium or inefficient flow of oil through the heater can cause the heater to become fouled.
Volkswagen Marine 3.0 litre V6 TDI 265-6 marine engine.This is a marine-modified version of Volkswagen Groups 3.0 V6 24v TDI CR automobile engine.. Marine automobile engines are types of automobile petrol-or diesel engines that have been specifically modified for use in the marine environment.
Oil cooling is the use of engine oil as a coolant, typically to remove surplus heat from an internal combustion engine. The hot engine transfers heat to the oil which then usually passes through a heat-exchanger, typically a type of radiator known as an oil cooler. The cooled oil flows back into the hot object to cool it continuously.
The viscosity of oil can be ten times greater than water, increasing the energy required to pump oil for cooling, and reducing the net power output of the engine. Comparing air and water, air has vastly lower heat capacity per gram and per volume (4000) and less than a tenth the conductivity, but also much lower viscosity (about 200 times lower ...
Some engines have an oil cooler, a separate small radiator to cool the engine oil. Cars with an automatic transmission often have extra connections to the radiator, allowing the transmission fluid to transfer its heat to the coolant in the radiator. These may be either oil-air radiators, as for a smaller version of the main radiator. More ...
Most shell-and-tube heat exchangers are either 1, 2, or 4 pass designs on the tube side. This refers to the number of times the fluid in the tubes passes through the fluid in the shell. In a single pass heat exchanger, the fluid goes in one end of each tube and out the other.
From 1958-1968 many vehicle manufacturers continued to use the next GM automatic transmission fluid specification, the Type "A" Suffix "A" fluid, in their transmissions. In 1966, Chrysler began releasing their own automatic transmission fluid specifications; see Mopar ATF for more information. GM ATF was the same color as engine oil through 1967.
A Yanmar 2GM20 marine diesel engine, installed in a sailboat. The center pulley is the crankshaft, the lower left one the seawater pump, the upper right one the alternator. The Yanmar 2GM20 is a series of inboard marine diesel engines manufactured by the Japanese company Yanmar Co. Ltd. It is used in a wide range of sailboats and motorboats.
Ads
related to: marine transmission oil coolers