Search results
Results from the WOW.Com Content Network
Aerogel contains particles that are 2–5 nm in diameter. After the process of creating aerogel, it will contain a large amount of hydroxyl groups on the surface. The hydroxyl groups can cause a strong reaction when the aerogel is placed in water, causing it to catastrophically dissolve in the water.
While not a gas, it is possible to synthesize an ultralight aerogel with a density less than air, the lightest recorded so far reaching a density approximately 1/6th that of air. [12] Aerogels don't float in ambient conditions, however, because air fills the pores of an aerogel's microstructure, so the apparent density of the aerogel is the sum ...
SEAgel is made of agar, a carbohydrate material that comes from kelp and red algae, and has a density of 200 mg/cm 3. [1] SEAgel can be made lighter than air using hydrogen, causing it to float or hang in the air. It insulates against temperature, noise, and electric current.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us
Aerographene or graphene aerogel is the least dense solid known to exist, at 160 g/m 3 (0.0100 lb/cu ft; 0.16 mg/cm 3; 4.3 oz/cu yd). [1] The material reportedly can be produced at the scale of cubic meters.
The solution has 1 mole or 1 equiv Na +, 1 mole or 2 equiv Ca 2+, and 3 mole or 3 equiv Cl −. An earlier definition, used especially for chemical elements , holds that an equivalent is the amount of a substance that will react with 1 g (0.035 oz) of hydrogen , 8 g (0.28 oz) of oxygen , or 35.5 g (1.25 oz) of chlorine —or that will displace ...
The working face of the suction cup is made of elastic, flexible material and has a curved surface. [3] When the center of the suction cup is pressed against a flat, non-porous surface, the volume of the space between the suction cup and the flat surface is reduced, which causes the air or water between the cup and the surface to be expelled past the rim of the circular cup.
Once saturated with water, the gel may be regenerated by heating it to about 120 °C (248 °F) [7] [8] for 1–2 hours. [7] Some types of silica gel will "pop" when exposed to enough water. This is caused by breakage of the silica spheres when contacting the water. [16] Regenerating silica gel is important for both economic and environmental ...