Search results
Results from the WOW.Com Content Network
It is part of the standard algorithm to add numbers together by starting with the rightmost digits and working to the left. For example, when 6 and 7 are added to make 13, the "3" is written to the same column and the "1" is carried to the left. When used in subtraction the operation is called a borrow.
One must multiply the leftmost digit of the original number by 3, add the next digit, take the remainder when divided by 7, and continue from the beginning: multiply by 3, add the next digit, etc. For example, the number 371: 3×3 + 7 = 16 remainder 2, and 2×3 + 1 = 7. This method can be used to find the remainder of division by 7.
Dividing 272 and 8, starting with the hundreds digit, 2 is not divisible by 8. Add 20 and 7 to get 27. The largest number that the divisor of 8 can be multiplied by without exceeding 27 is 3, so it is written under the tens column. Subtracting 24 (the product of 3 and 8) from 27 gives 3 as the remainder.
If the top number is too small to subtract the bottom number from it, we add 10 to it; this 10 is "borrowed" from the top digit to the left, which we subtract 1 from. Then we move on to subtracting the next digit and borrowing as needed, until every digit has been subtracted. Example: [citation needed]
Using scientific notation, a number is decomposed into the product of a number between 1 and 10, called the significand, and 10 raised to some integer power, called the exponent. The significand consists of the significant digits of the number, and is written as a leading digit 1–9 followed by a decimal point and a sequence of digits 0–9.
To find the product of two multiple digit numbers, make a two column table. In the left column write the digits of the first number, one below the other. For each digit in the left column, multiply that digit and the second number and record it in the right column. Finally, add all the numbers of the right column together.
For example, through the standard addition algorithm, the sum can be obtained by following three rules: a) line up the digits of each addend by place value, longer digit addends should go on top, b) each addend can be decomposed -- ones are added with ones, tens are added with tens, and so on, and c) if the sum of the digits of the current place value is ten or greater, then the number must be ...
To subtract one number from another, the method of nine's complement was used. The only two differences between an addition and a subtraction are the position of the display bar (direct versus complement) and the way the first number is entered (direct versus complement). For a 10-digit wheel (N), the fixed outside wheel is numbered from 0 to 9 ...