enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Reveal (carpentry) - Wikipedia

   en.wikipedia.org/wiki/Reveal_(carpentry)

   Reveal: Door frame example. In carpentry, a reveal is a feature resembling a rabbet, but constructed of separate pieces of wood.A reveal may typically be seen at the edge of a door or window, where the face molding is set back, often by a distance from 3/16" (5 mm) to 1/2" (12 mm).

3. Frame and panel - Wikipedia

   en.wikipedia.org/wiki/Frame_and_panel

   Panels are made slightly smaller than the available space within the frame to provide room for movement. Wood will expand and contract across the grain, and a wide panel made of solid wood could change width by a half of an inch, warping the door frame. By allowing the wood panel to float, it can expand and contract without damaging the door.

4. Crown molding - Wikipedia

   en.wikipedia.org/wiki/Crown_molding

   A compound crown molding built up out of several individual trim elements Decorative pilaster of natural cherry hardwood topped with crown molding Crown molding may be a complex build-up of multiple trim elements, in this case built-out slightly above a window with short 90-degree returns The relief on this short 90-degree return of crown molding was back-cut with a coping saw

5. Ogee - Wikipedia

   en.wikipedia.org/wiki/Ogee

   A building's surface detailing, inside and outside, often includes decorative moulding, and these often contain ogee-shaped profiles—consisting (from low to high) of a concave arc flowing into a convex arc, with vertical ends; if the lower curve is convex and higher one concave, this is known as a Roman ogee, although frequently the terms are used interchangeably and for a variety of other ...

6. Molding (decorative) - Wikipedia

   en.wikipedia.org/wiki/Molding_(decorative)

   Casing: Finish trim around the sides of a door or window opening covering the gap between finished wall and the jam or frame it is attached to. Cartouche (in French) escutcheon : Framed panel in the form of a scroll with an inscribed centre, or surrounded by compound mouldings decorated with floral motifs

7. Scarf joint - Wikipedia

   en.wikipedia.org/wiki/Scarf_joint

   The joint is formed by cutting opposing tapered ends on each member which are then fitted together. When working with wood, this gives better long grain to long grain gluing surface, which yields a stronger joint than would be achieved with a simple butt joint. The tapers are generally cut at an angle between 1:8 to 1:10.

8. Toenailing - Wikipedia

   en.wikipedia.org/wiki/Toenailing

   Toenailing or skew-nailing is a viable, structurally sound method [1] of the driving of a nail at a roughly 30° [2] angle to fasten two pieces of wood together, typically with their grains perpendicular. The term comes colloquially from fastening wood at the bottom, or toe, of the board.

9. Draft (engineering) - Wikipedia

   en.wikipedia.org/wiki/Draft_(engineering)

   Consider the fabrication of a hollow plastic box, without lid. Once the plastic has hardened around the mold, the mold must be removed. As the plastic hardens, it may contract slightly. By tapering the sides of the mold by an appropriate "draft angle", for instance 2° (two degrees), the mold will be easier to remove.