Search results
Results from the WOW.Com Content Network
These may involve the choice of major engine components or systems, such as the use of dry sump lubrication system over a wet sump system. Alternately, this can be effected through substitution of minor components available as aftermarket modifications, such as exchanging a directly engine-driven fan for one equipped with a fan clutch or an ...
A petrol engine (gasoline engine in American and Canadian English) is an internal combustion engine designed to run on petrol (gasoline). Petrol engines can often be adapted to also run on fuels such as liquefied petroleum gas and ethanol blends (such as E10 and E85). They may be designed to run on petrol with a higher octane rating, as sold at ...
The ignition system of an internal combustion engines depends on the type of engine and the fuel used. Petrol engines are typically ignited by a precisely timed spark, and diesel engines by compression heating. Historically, outside flame and hot-tube systems were used, see hot bulb engine.
Although direct injection has only become commonly used in gasoline engines since 2000, diesel engines have used fuel directly injected into the combustion chamber (or a pre-combustion chamber) since the first successful prototype in 1894. An early prototype of a GDI engine was built in Germany in 1916 for the Junkers airplane. The engine was ...
In a naturally aspirated engine, air for combustion (Diesel cycle in a diesel engine or specific types of Otto cycle in petrol engines, namely petrol direct injection) or an air/fuel mixture (traditional Otto cycle petrol engines), is drawn into the engine's cylinders by atmospheric pressure acting against a partial vacuum that occurs as the piston travels downwards toward bottom dead centre ...
This engine was fuelled by gas vapours, used the piston's intake stroke to draw in outside air, and the air/fuel mixture was ignited by an external flame. [6] Another gas engine was also patented in 1794 by Thomas Mead. [7] 1801: The concept of using compression in a two-stroke gas engine was theorised by French engineer Philippe LeBon D ...
Also in 1957, General Motors introduced the Rochester Ramjet option, consisting of a fuel injection system for the V8 engine in the Chevrolet Corvette. During the 1960s, fuel injection systems were also produced by Hilborn, [46] SPICA [47] and Kugelfischer. Up until this time, the fuel injection systems had used a mechanical control system.
Cutaway view of the fuel system for the Ford Model T engine, showing the gravity-feed fuel supply, carburetor cutaway, and intake stream. [4] The Ford Model T engine had one carburetor, a side-draft, single-venturi unit. Its choke and throttle valves were controlled manually; the latter was with a hand lever rather than a foot pedal. The ...