Search results
Results from the WOW.Com Content Network
The side-stick is used in many modern military fighter aircraft, such as the F-16 Fighting Falcon, Mitsubishi F-2, Dassault Rafale, and F-22 Raptor, F-35 Lightning 2, Chengdu J-20, AIDC F-CK 1 Ching-Kuo and also on civil aircraft, such as the Sukhoi Superjet 100, Airbus A320 and all subsequent Airbus aircraft, [2] including the largest passenger jet in service, the Airbus A380.
The twisted nematic effect (TN-effect) was a major technological breakthrough that made the manufacture of large, thin liquid crystal displays practical and cost competitive. Unlike earlier flat-panel displays, TN-cells did not require a current to flow for operation and used low operating voltages suitable for use with batteries.
The origin and invention of the Bowden cable are open to some dispute, confusion and myth. The invention of the Bowden cable has been popularly attributed to Sir Frank Bowden, one time owner of the Raleigh Bicycle Company who, circa 1902, was reputed to have started replacing the rigid rods used for brakes with a flexible wound cable but no evidence for this exists.
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
Air brakes are used to increase drag. Spoilers might act as air brakes, but are not pure air brakes as they also function as lift-dumpers or in some cases as roll control surfaces. Air brakes are usually surfaces that deflect outwards from the fuselage (in most cases symmetrically on opposing sides) into the airstream in order to increase form ...
Target-type thrust reversal, particularly this design, was invented in 1968. This invention is stated to be an improvement to previous design. [2] As early as 1963, an invention called "two part thrust reversal" appeared with a similar deflector door design.
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
These include dc brush, dc brushless, stepper, or in some cases, even induction motors. It all depends on the application requirements and the loads the actuator is designed to move. For example, a linear actuator using an integral horsepower AC induction motor driving a lead screw can be used to operate a large valve in a refinery.