Search results
Results from the WOW.Com Content Network
Soffit vents under the eaves normally provide the low vents. Louvered vents in gables can provide the high vents in small houses or short gables. [citation needed] If a ridge is open, some metal roofing systems can install ridge vents along the entire ridge line of the roof. [7] Various types of turbine ventilators and exhaust fans can assist ...
A ridge vent is a type of vent installed at the peak of a sloped roof which allows warm, humid air to escape a building's attic. Ridge vents are most common on shingled residential buildings. Ridge vents are also used in industrial warehouses to help release the hot air and help circulate comfortable air inside the building .
Eaves of a house in Northern Australia. The white underside would be referred to as a soffit. In this example the soffit is fixed to the slope of the rafters. The dark grey fascia boards form the outer edge and have a groove to receive the soffit lining sheets which cover the rafter tails. Boxed in soffit on a house in Northern Florida, United ...
Pavilion roof : A low-pitched roof hipped equally on all sides and centered over a square or regular polygonal floor plan. [10] The sloping sides rise to a peak. For steep tower roof variants use Pyramid roof. Pyramid roof: A steep hip roof on a square building.
During the winter, ACH may range from 0.50 to 0.41 in a tightly air-sealed house to 1.11 to 1.47 in a loosely air-sealed house. [12] ASHRAE now recommends ventilation rates dependent upon floor area, as a revision to the 62-2001 standard, in which the minimum ACH was 0.35, but no less than 15 CFM/person (7.1 L/s/person).
A powered attic ventilator, or attic fan, is a ventilation fan that regulates the heat level of a building's attic by exhausting hot air. A thermostat is used to automatically turn the fan off and on, while sometimes a manual switch is used. An attic fan can be gable mounted or roof mounted. Additional vents are required to draw in the fresh ...
Ventilation on the downdraught system, by impulsion, or the 'plenum' principle, applied to schoolrooms (1899) Natural ventilation is the ventilation of a building with outside air without using fans or other mechanical systems. It can be via operable windows, louvers, or trickle vents when spaces are small and the architecture permits.
A basement apartment is an apartment located below street level, underneath another structure—usually an apartment building, but possibly a house or a business. Cities in North America are beginning to recognize these units as a vital source of housing in urban areas and legally define them as an accessory dwelling unit or "ADU".