Search results
Results from the WOW.Com Content Network
This number is followed by the letter 'R' to indicate a receptacle (socket) or 'P' to indicate a plug (prongs). As an example, the 5-15R is the common 125 V two-pole, three-wire receptacle rated for 15 A. The L5-15R, while sharing the same electrical rating, is a locking design that is not physically compatible with the straight-blade 5-15 design.
BS 546, Two-pole and earthing-pin plugs, socket-outlets and socket-outlet adaptors for AC (50–60 Hz) circuits up to 250 V is an older British Standard for three-pin AC power plugs and sockets. Originally published in April 1934, it was updated by a 1950 edition which is still current, [1] with eight amendments up to 1999. BS 546 is also the ...
"Switched socket-outlets and connectors with or without interlock" applies to self-contained products that combine within a single enclosure, a socket-outlet or connector according to IEC 60309-1 or IEC 60309-2 and a switching device, with a rated operating voltage not exceeding 1000 VDC or VAC and 500 Hz, and a rated current not exceeding 800 A.
CEE 7 is a standard for alternating-current plugs and sockets.First published in 1951 by the former International Commission on the Rules for the Approval of Electrical Equipment (), it unified standards produced by several continental European countries.
The Swiss standard SN 441011 (until 2019 SEV 1011) Plugs and socket-outlets for household and similar purposes. [19] defines a hierarchical system of plugs and sockets including both single and three phase connectors. Sockets will accept plugs with the same or fewer number of pins and the same or lower ratings. [20]
SN 441011-2-2: Multiple and intermediate adapters, extension cables, socket strips as well as travel and fixed adapters; SN 441011-2-3: Advices; Products according to the outdated standard SEV 1011:2009 may only be manufactured or imported until February 28, 2022. Until 2019, SEV 1011:2009 (ASE1011 / 1959 SW10A-R) was the relevant standard.
Also called chordal or DC resistance This corresponds to the usual definition of resistance; the voltage divided by the current R s t a t i c = V I. {\displaystyle R_{\mathrm {static} }={V \over I}.} It is the slope of the line (chord) from the origin through the point on the curve. Static resistance determines the power dissipation in an electrical component. Points on the current–voltage ...
The International System of Electrical and Magnetic Units is an obsolete system of units used for measuring electrical and magnetic quantities. It was proposed as a system of practical international units (e.g., the international ampere, the international ohm, the international volt) by unanimous recommendation at the International Electrical Congress (Chicago, 1893), discussed at other ...