Search results
Results from the WOW.Com Content Network
For a multiple sound source speaker system, the measurement should be carried out for all sound sources (woofer, bass-reflex vent, midrange speaker, tweeter...). These measurements are easy to carry out, can be done at almost any room, more punctual than in-box measurements, and predicts half-space measurements, but without directivity information.
Bass reflex enclosure schematic (cross-section). RCA bass reflex shelf stereo speakers.. A bass reflex system (also known as a ported, vented box or reflex port) is a type of loudspeaker enclosure that uses a port (hole) or vent cut into the cabinet and a section of tubing or pipe affixed to the port.
These enclosures are sensitive to small variations in driver characteristics and require special quality control concern for uniform performance across a production run. Bass ports are widely used in subwoofers for PA systems and sound reinforcement systems, in bass amp speaker cabinets and in keyboard amp speaker cabinets.
Lindos Electronics expanded the concept, retaining the FSK concept, and inventing segmented sequence testing, which separated each test into a 'segment' starting with an identifying character transmitted as 110-baud FSK so that these could be regarded as 'building blocks' for a complete test suited to a particular situation. Regardless of the ...
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
A speaker that can handle 200 watts thermally at 200 Hz, may sometimes be damaged by only a few watts at some very low frequency, like 10 Hz. Power handling specifications are usually generated destructively, by long-term industry standard noise signals (IEC 268, for example) that filter out low frequencies and test only the thermal capability ...
The two most common types of speaker enclosure are acoustic suspension (sometimes called pneumatic suspension) and bass reflex.In both cases, the tuning affects the lower end of the driver's response, but above a certain frequency, the driver itself becomes the dominant factor and the size of the enclosure and ports (if any) become irrelevant.
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]