Search results
Results from the WOW.Com Content Network
Bermuda rig takes its name from Bermuda, where it was developed in the 17th century. The term Marconi, a reference to the inventor of the radio, Guglielmo Marconi, became associated with this configuration in the early 20th century, because the wires that stabilize the mast of a Bermuda rig reminded observers of the wires on early radio masts. [2]
Many mast-aft rigs utilize a small mainsail and multiple staysails that can resemble some cutter rigs. A cutter is a single masted vessel, differentiated from a sloop either by the number of staysails, with a sloop having one and a cutter more than one, or by the position of the mast, with a cutter's mast being located between 50% and 70% of the way from the aft to the front of the sailplan ...
Part of the design of the B&R rig involves inducing a "pre-bend" in the mast which provides some of the side-to-side and fore-and-aft stability of the rig. [2] [3] [4] The pre-bend is achieved by tensioning the reverse diagonals and certain other so called intermediate shrouds. Because the spreaders are swept back at approximately a 25° to 30 ...
Fore-and-aft rig features sails that run fore and aft (along the length of the sailing craft), controlled by lines called "sheets", that changes sides, as the bow passes through the wind from one side of the craft to the other. Fore-and-aft rig variants include: Bermuda rig (also known as a Marconi rig) features a three-sided mainsail.
The Bermuda rig, also known as a Marconi rig, refers to a configuration of mast and rigging with a triangular sail set aft of the mast with its headsail raised to the top of the mast. Its luff runs down the mast and is normally attached to the mast for its entire length.
A masthead rig on a sailing vessel consists of a forestay and backstay both attached at the top of the mast. [1] The Bermuda rig can be split into two groups: the masthead rig and the fractional rig. The masthead rig has larger and more headsails, and a smaller mainsail, compared to the fractional rig.
8 – mast 9 – spreader 10 – shroud 11 – sheet 12 – boom 13 - mast 14 – spinnaker pole 15 – backstay 16 – forestay 17 – boom vang Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts. [1]
Gunter rigged Lobster 12.5. Gunter rig is a configuration of sail and spars used in sailing. It is a fore and aft sail set abaft (behind) the mast. The lower half of the luff (front) of the sail is attached to the mast, and the upper half is fastened to a spar which is approximately vertical and reaches above the top of the mast.