enow.com Web Search

  1. Ads

    related to: parts of booster pump

Search results

  1. Results from the WOW.Com Content Network
  2. Booster pump - Wikipedia

    en.wikipedia.org/wiki/Booster_pump

    A booster pump is a machine which increases the pressure of a fluid. It may be used with liquids or gases, and the construction details vary depending on the fluid.

  3. Automobile accessory power - Wikipedia

    en.wikipedia.org/wiki/Automobile_accessory_power

    The vacuum is only an assist and the brakes can still function, requiring greater force, if the booster vacuum is used up. Many older vehicles used vacuum-powered windshield wipers. Loss of manifold vacuum when the engine was working hard, or at wide open throttle, necessitated using a vacuum booster pump which was usually part of the fuel pump.

  4. Diaphragm pump - Wikipedia

    en.wikipedia.org/wiki/Diaphragm_pump

    The basic working principle of an air-operated double diaphragm pump. Cross-section sketch of diaphragm fuel pump Air-operated double diaphragm pump. A diaphragm pump (also known as a Membrane pump) is a positive displacement pump that uses a combination of the reciprocating action of a rubber, thermoplastic or teflon diaphragm and suitable valves on either side of the diaphragm (check valve ...

  5. Diffusion pump - Wikipedia

    en.wikipedia.org/wiki/Diffusion_pump

    An oil diffusion pump is used to achieve higher vacuum (lower pressure) than is possible by use of positive displacement pumps alone. Although its use has been mainly associated within the high-vacuum range, down to 1 × 10 −9 mbar (1 × 10 −7 Pa), diffusion pumps today can produce pressures approaching 1 × 10 −10 mbar (1 × 10 −8 Pa) when properly used with modern fluids and accessories.

  6. Circulator pump - Wikipedia

    en.wikipedia.org/wiki/Circulator_pump

    This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...

  7. Rotary vane pump - Wikipedia

    en.wikipedia.org/wiki/Rotary_vane_pump

    An eccentric rotary vane pump Another eccentric rotary-vane pump design. Note that modern pumps have an area contact between rotor and stator (and not a line contact). 1. pump housing 2. rotor 3. vanes 4. spring. A rotary vane pump is a type of positive-displacement pump that consists of vanes mounted to a rotor that rotates inside a cavity. In ...

  1. Ads

    related to: parts of booster pump