Search results
Results from the WOW.Com Content Network
A quarter chain, or 25 links, measures 16 feet 6 inches (5.03 m) and thus measures a rod (or pole). Ten chains measure a furlong and 80 chains measure a statute mile. [1] Gunter's chain reconciled two seemingly incompatible systems: the traditional English land measurements, based on the number four, and decimals based on the number 10.
A Gunter's chain showing the individual links. The link (usually abbreviated as "l.", "li." or "lnk."), sometimes called a Gunter’s link, is a unit of length formerly used in many English-speaking countries. In US customary units modern definition, the link is exactly 66 ⁄ 100 of a US survey foot, [1] or exactly 7.92 inches or 20.1168 cm.
Distances were always measured in chains and links, based on Edmund Gunter's 66-foot measuring chain. The chain – an actual metal chain – was made up of 100 links, each being 7.92 inches (201 mm) long. Eighty chains constitute one U.S. survey mile (which differs from the international mile by a few millimeters).
The only exceptions to this rule are special requirements for measurement in feet in mineral surveys and townsite surveys. [13] Linear Measurement 1 Chain = 100 links or 66 feet 1 Mile = 80 chains or 5,280 feet. Area Measurement 1 Acre = 10 square chains or 43,560 square feet 1 square mile = 640 acres
American surveyors use a decimal-based system of measurement devised by Edmund Gunter in 1620. The base unit is Gunter's chain of 66 feet (20 m) which is subdivided into 4 rods, each of 16.5 ft or 100 links of 0.66 feet. A link is abbreviated "lk", and links "lks", in old deeds and land surveys done for the government.
Local police in Colorado shot and killed a mountain lion after the animal roamed onto a school's grounds and came close to students and families, according to the responding department.
Europeans used chains with links of a known length such as a Gunter's chain, or measuring tapes made of steel or invar. To measure horizontal distances, these chains or tapes were pulled taut to reduce sagging and slack. The distance had to be adjusted for heat expansion. Attempts to hold the measuring instrument level would also be made.
A simple boundary survey can cost anywhere from $100 to $600, while a mortgage survey for buying a house costs about $500, according to data from HomeAdvisor. A survey for fencing can run up to ...