Search results
Results from the WOW.Com Content Network
GM's Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydramatic introduced in 1940. [1] The Hydramatic was a big success, and had been installed in the majority of GM models by 1950.
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints. The Dana 70 axle only came with 5.13:1, 4.88,5.31 [citation needed] gear ratios and had a GAWR of [citation needed] these axles were rated at 7-9klbs as seen on 5500 door ...
This ring and pinion is significantly stronger with a better pinion to ring gear tooth contact patch and angle. It was typically used in the back of jeep JKs, Isuzus and Nissan pickups. This ring and pinion does share some components and can be adapted into an earlier Dana 44 but requires some work, different bearings and spacers.
During the development of the 9TXX, GM received 60 new patents while building 800 prototypes. [4] It was developed from the 6T41 (Gen 3) [ 5 ] and designed to occupy approximately the same volume as that prior six-speed automatic and retain that transmission's on-axis design, which aligns all the planetary gears with the crankshaft .
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.