Ad
related to: insulation under concrete slab detail dwg software
Search results
Results from the WOW.Com Content Network
UFAD systems use an underfloor supply plenum located between the structural concrete slab and a raised floor system to supply conditioned air to supply outlets (usually floor diffusers), located at or near floor level within the occupied space. Air returns from the room at ceiling level or the maximum allowable height above the occupied zone.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
Insulation may be categorized by its composition (natural or synthetic materials), form (batts, blankets, loose-fill, spray foam, and panels), structural contribution (insulating concrete forms, structured panels, and straw bales), functional mode (conductive, radiative, convective), resistance to heat transfer, environmental impacts, and more.
Shop drawings are produced by contractors and suppliers under their contract with the owner. The shop drawing is the manufacturer’s or the contractor’s drawn version of information shown in the construction documents. [1] The shop drawing normally shows more detail than the construction documents.
Provided the slab has air channels like the Trombe wall, which run through it in the north-south direction and are vented to the interior air space through the concrete slab floor just inside the north and south walls, vigorous air thermosiphoning through the slab still occurs as in the vertical Trombe wall, distributing the impounded heat ...
Insulating concrete form or insulated concrete form (ICF) is a system of formwork for reinforced concrete usually made with a rigid thermal insulation that stays in place as a permanent interior and exterior substrate for walls, floors, and roofs.
Cast-in-place concrete or Cast-in-situ concrete is a technology of construction of buildings where walls and slabs of the buildings are cast at the site in formwork. [1] This differs from precast concrete technology where slabs are cast elsewhere and then brought to the construction site and assembled. [ 2 ]
A common example is polyethylene sheeting laid under a concrete slab to prevent the concrete from gaining moisture through capillary action. [5] A DPM may be used for the DPC. Integral damp proofing in concrete involves adding materials to the concrete mix to make the concrete itself impermeable. [4]
Ad
related to: insulation under concrete slab detail dwg software