Search results
Results from the WOW.Com Content Network
Standard sea-level conditions (SSL), [1] also known as sea-level standard (SLS), defines a set of atmospheric conditions for physical calculations. The term "standard sea level " is used to indicate that values of properties are to be taken to be the same as those standard at sea level, and is done to define values for use in general calculations.
A wet-bulb temperature at 500 hPa in a tropical atmosphere of −13.2 °C (8.2 °F) is required to initiate convection if the water temperature is 26.5 °C (79.7 °F), and this temperature requirement increases or decreases proportionally by 1 °C in the sea surface temperature for each 1 °C change at 500 hpa.
For Pilots: At sea level, Altimeter:29.92 in/Hg at 15 °C (59 °F) The "standard day" model of the atmosphere is defined at sea level, with certain present conditions such as temperature and pressure. But other factors, such as humidity, further alter the nature of the atmosphere, and are also defined under standard day conditions:
This means that when the outside temperature reaches 90 degrees, sand can heat up to be over more than 120 degrees. Human skin begins to feel pain at 111 degrees Fahrenheit, according to the ...
Graph showing ocean temperature versus depth on the vertical axis. The graph shows several thermoclines (or thermal layers) based on seasons and latitude. The temperature at zero depth is the sea surface temperature. The ocean temperature plays a crucial role in the global climate system, ocean currents and for marine habitats.
A Assuming an altitude of 194 metres above mean sea level (the worldwide median altitude of human habitation), an indoor temperature of 23 °C, a dewpoint of 9 °C (40.85% relative humidity), and 760 mmHg sea level–corrected barometric pressure (molar water vapor content = 1.16%). B Calculated values *Derived data by calculation.
This standard is also called normal temperature and pressure (abbreviated as NTP). However, a common temperature and pressure in use by NIST for thermodynamic experiments is 298.15 K (25 °C, 77 °F) and 1 bar (14.5038 psi , 100 kPa ).
With a temperature lapse rate of −6.5 °C (-11.7 °F) per km (roughly −2 °C (-3.6 °F) per 1,000 ft), the table interpolates to the standard mean sea level values of 15 °C (59 °F) temperature, 101,325 pascals (14.6959 psi) (1 atm) pressure, and a density of 1.2250 kilograms per cubic meter (0.07647 lb/cu ft).