Search results
Results from the WOW.Com Content Network
This is an accepted version of this page This is the latest accepted revision, reviewed on 31 December 2024. Mechanical device that connects and disconnects two rotating shafts or other moving parts For other uses, see Clutch (disambiguation). Friction disk for a dry clutch A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. The clutch's ...
Hele-Shaw clutch, sectioned A single pair of plates of the Hele Shaw clutch Section through a stack of plates . The Hele-Shaw clutch was an early form of multi-plate wet clutch, in use around 1900. It was named after its inventor, Professor Henry Selby Hele-Shaw, who was noted for his work in viscosity and flows through small gaps between ...
VTD AWD uses a multi-plate clutch in conjunction with planetary gears in the center differential and a viscous coupling rear differential to distribute torque up to a 50:50 ratio. With the addition of VDC, all torque can be sent to a single wheel. [1] [4] [5]
BorgWarner's original design called for using both a software controlled electromagnetic multi-disc (also called multi-plate) clutch pack and a planetary or bevel geared center differential together. The first prototype system was crude, and its original clutch pack controller was a rheostat. [1]
A dual-clutch transmission (DCT) (sometimes referred to as a twin-clutch transmission) is a type of multi-speed vehicle transmission system, that uses two separate clutches for odd and even gear sets. [1] The design is often similar to two separate manual transmissions with their respective clutches contained within one housing, and working as ...
The 1996 sixth-generation Honda Civic introduced a pulley-based Honda Multi Matic (HMM) CVT which included a multi-plate clutch, not a torque converter, to prevent idle creep. [41] Use of CVTs then spread in the following years to models including the 1998 Nissan Cube, 1999 Rover 25 and 1999 Audi A6. [42]
This page was last edited on 11 November 2014, at 09:09 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Manual control of the multi-plate clutch systems via a lever behind the steering wheel is used to launch the cars. DTM currently uses a Hewland DTT-200 6-speed sequential transmission with steering-wheel-mounted shift paddles, which was introduced for the 2012 season with the new rule change.