enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   A reducer reduces the pipe size from a larger to a smaller bore (inner diameter). Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the ...

3. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

4. Coupling (piping) - Wikipedia

   en.wikipedia.org/wiki/Coupling_(piping)

   Examples of adapters include one end BSP threaded with the other NPT threaded, and one end threaded with the other a plain socket for brazing. A coupling whose ends use the same connection method but are of different sizes is called a reducing coupling or reducer. An example is a 3/4" NPT to 1/2" NPT coupling.

5. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working. The most common flare fitting standards in use today are the 45° SAE flare [ 2 ] [ 3 ] ,the 37° JIC flare, and the 37° AN flare.

6. EIAJ connector - Wikipedia

   en.wikipedia.org/wiki/EIAJ_connector

   This is a unique-looking barrel connector, apparently intended for providing a DC output jack (most DC jacks are used for power input).. Possibly available in multiple voltage ranges, the one for voltage classification 2 (3.15 to 6.3 V) has an outside diameter of 4.75 mm and a protruding pin of 2.5 mm diameter.

7. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   A 5 ⁄ 16 inch torque wrench is required for this, set to 3–5 in·lbf (0.3 to 0.6 N·m) for brass, and 7–10 in·lbf (0.8 to 1.1 N·m) for stainless steel connectors. Flats are sometimes also provided on the cable side of the connector assembly so that a second wrench can be used to prevent it from rotating and damaging the joint to the cable.

8. Dancing Trombonist Goes Viral (Again) for Stealing the Show ...

   www.aol.com/dancing-trombonist-goes-viral-again...

   Jonathan Arons, who is also known as the "dancing trombonist," stole the show at a wedding reception on Nov. 15. The Grammy-winning musician and entertainer wowed wedding guests with his animated ...

9. Eccentric reducer - Wikipedia

   en.wikipedia.org/wiki/Eccentric_reducer

   Eccentric reducers are used at the suction side of pumps to ensure air does not accumulate in the pipe. The gradual accumulation of air in a concentric reducer could result in a large bubble that could eventually cause the pump to stall or cause cavitation when drawn into the pump. Eccentric reducers exhibit a unique design with one side having ...