Search results
Results from the WOW.Com Content Network
cubic metre: m3 m 3: US spelling: cubic meter one kilolitre 1.0 m 3 (35 cu ft) cubic centimetre: cm3 cm 3: US spelling: cubic centimeter one millilitre 1.0 cm 3 (0.061 cu in) cc cc cubic millimetre: mm3 mm 3: US spelling: cubic millimeter: 1.0 mm 3 (6.1 × 10 −5 cu in) non-SI metric: kilolitre: kl kl US spelling: kiloliter one cubic metre 1.0 ...
For example, if a unit has the symbol "imp gal", and if the link is @[[Gallon]], then if the symbol is linked, it would appear as "imp gal" ("imp" and "gal" link two different articles). The Links section defines exceptions for unit codes with an SI prefix, where the linked article is different from that of the base unit.
{{convert|123|cuyd|m3+board feet}} → 123 cubic yards (94 m 3; 40,000 board feet) The following converts a pressure to four output units. The precision is 1 (1 decimal place), and units are abbreviated and linked.
Oil conversion factor from m³ to bbl (or stb) is 6.28981100 Gas conversion factor from standard m³ to scf is 35.314666721 Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
A standard cubic foot (scf) is a unit representing the amount of gas (such as natural gas) contained in a volume of one cubic foot at reference temperature and pressure conditions. It is the unit commonly used when following the customary system , a collection of standards set by the National Institute of Standards and Technology .
This volume of natural gas has the same energy content as one US gallon of gasoline (based on lower heating values: 900 BTU/cu ft (9.3 kWh/m 3) of natural gas and 114,000 BTU/US gal (8.8 kWh/L) for gasoline). [22] One GGE of CNG pressurized at 2,400 psi (17 MPa) is 0.77 cubic feet (22 litres; 5.8 US gallons).
In oceanography, the sverdrup (symbol: Sv) is a non-SI metric unit of volumetric flow rate, with 1 Sv equal to 1 million cubic metres per second (264,172,052 US gal/s). [1] [2] It is equivalent to the SI derived unit cubic hectometer per second (symbol: hm 3 /s or hm 3 ⋅s −1): 1 Sv is equal to 1 hm 3 /s.
A Fixture Unit is not a flow rate unit but a design factor. A fixture unit is equal to 1 cubic foot (0.028 m 3) of water drained in a 1 + 1 ⁄ 4 inches (32 mm) diameter pipe over one minute. [2] One cubic foot of water is roughly 7.48 US gallons (28.3 L; 6.23 imp gal). A Fixture Unit is used in plumbing design for both water supply and waste ...