Search results
Results from the WOW.Com Content Network
With a VLAN Management Policy Server (VMPS), an administrator can assign switch ports to VLANs dynamically based on information such as the source MAC address of the device connected to the port or the username used to log onto that device. As a device enters the network, the switch queries a database for the VLAN membership of the port that ...
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
A VLAN Management Policy Server (VMPS) is a network switch that contains a mapping of device information to VLAN.. The primary goal of VMPS is VLAN assignment for general network management purposes, but can also be used for providing security through segregating clients with an unknown MAC address, or through further extension of the protocol to provide login for Cisco ACLs.
Management Information Base (MIB) definitions for VLAN Bridges Incorporated into 802.1Q-2011 802.1aj-2009 Two Port MAC Relay (TPMR) Incorporated into 802.1Q-2011 802.1Qav-2009 Forwarding and Queuing Enhancements for Time-sensitive Streams: Incorporated into 802.1Q-2011 802.1Qaw-2009 Management of Data-Driven and Data-Dependent Connectivity Faults
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
Private VLAN, also known as port isolation, is a technique in computer networking where a VLAN contains switch ports that are restricted such that they can only communicate with a given uplink. The restricted ports are called private ports. Each private VLAN typically contains many private ports, and a single uplink.
IEEE 802.1ah is an amendment to the IEEE 802.1Q networking standard which adds support for Provider Backbone Bridges.It includes an architecture and a set of protocols for routing over a provider's network, allowing interconnection of multiple provider bridge networks without losing each customer's individually defined VLANs.
Static configuration of VLAN membership information via management mechanisms, which allow configuration of static VLAN registration entries. Combined static and dynamic configuration, in which some VLANs are configured via management mechanisms and for other VLANs, MVRP is relied on to establish the configuration.