Search results
Results from the WOW.Com Content Network
ounce (avoirdupois) per gallon (US fluid) oz/gal ≡ oz/gal ≈ 7.489 151 707 kg/m 3: pound (avoirdupois) per cubic foot lb/ft 3: ≡ lb/ft 3: ≈ 16.018 463 37 kg/m 3: pound (avoirdupois) per cubic inch lb/in 3: ≡ lb/in 3: ≈ 2.767 990 471 × 10 4 kg/m 3: pound (avoirdupois) per gallon (imperial) lb/gal ≡ lb/gal ≈ 99.776 372 66 kg/m 3 ...
HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
For medium- and high-density polyethylene the melting point is typically in the range 120 to 130 °C (248 to 266 °F). The melting point for average commercial low-density polyethylene is typically 105 to 115 °C (221 to 239 °F).
— "Values ranging from 21.3 to 21.5 gm/cm 3 at 20 °C have been reported for the density of annealed platinum; the best value being about 21.45 gm/cm 3 at 20 °C." 21.46 g/cm 3 — Rose, T. Kirke. The Precious Metals, Comprising Gold, Silver and Platinum .
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
Typical densities are 29 to 120 kg/m 3 (49 to 202 lb/cu yd) with the lower figure being common. [1] Densities as low as 14 kg/m 3 (24 lb/cu yd) can be produced. [2] Base polymer for EPE foams range from Low-density polyethylene (LDPE) to High-density polyethylene (HDPE). [2]
The contribution of the muscle to the specific heat of the body is approximately 47%, and the contribution of the fat and skin is approximately 24%. The specific heat of tissues range from ~0.7 kJ · kg−1 · °C−1 for tooth (enamel) to 4.2 kJ · kg−1 · °C−1 for eye (sclera). [13]