enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Valve - Wikipedia

   en.wikipedia.org/wiki/Valve

   The shut off butterfly valve for a Francis turbine at Gordon Power Station, Tasmania Ball valve The "seat" is the interior surface of the body which contacts the disc to form a leak-tight seal. In discs that move linearly or swing on a hinge or trunnion, the disc comes into contact with the seat only when the valve is shut.

3. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   Saddle valve: where allowed, is used to tap a pipe for a low-flow need; Schrader valve: holds the air inside automobile tires; Security valve, a type of automatic shut-off valve (ASV): used to stop the flow of natural gas upon sudden pressure changes. Increased pressure or decreased pressure closes the valve (without using any external power ...

4. Shut-off nozzle - Wikipedia

   en.wikipedia.org/wiki/Shut-off_nozzle

   Bolt Shut-off Nozzle type BHP - pneumatic or hydraulic actuation. A shut-off bolt, positioned perpendicular to the melt channel moves up and down according to actuation, and thus shuts off/opens the melt flow. This nozzle type has a single melt channel. It therefore does not require rerouting of the melt around the shut-off mechanism.

5. Ball valve - Wikipedia

   en.wikipedia.org/wiki/Ball_valve

   In reduced bore (sometimes reduced port) ball valves, flow through the valve is one pipe size smaller than the valve's pipe size resulting in the flow area being smaller than the pipe. As the flow discharge remains constant and is equal to the area of flow (A) times velocity (V), A 1 V 1 = A 2 V 2 {\displaystyle A_{1}V_{1}=A_{2}V_{2}} the ...

6. Shutdown valve - Wikipedia

   en.wikipedia.org/wiki/Shutdown_valve

   A shutdown valve (also referred to as SDV or emergency shutdown valve, ESV, ESD, or ESDV; or safety shutoff valve) is an actuated valve designed to stop the flow of a hazardous fluid upon the detection of a dangerous event. This provides protection against possible harm to people, equipment or the environment.

7. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...