Search results
Results from the WOW.Com Content Network
The CLTD/CLF/SCL (cooling load temperature difference/cooling load factor/solar cooling load factor) cooling load calculation method was first introduced in the 1979 ASHRAE Cooling and Heating Load Manual (GRP-158) [1] The CLTD/CLF/SCL Method is regarded as a reasonably accurate approximation of the total heat gains through a building envelope ...
The above equation only takes into account the temperature differences and ignores two important parameters, being 1) solar radiative flux; and 2) infrared exchanges from the sky. The concept of T sol-air was thus introduced to enable these parameters to be included within an improved calculation. The following formula results:
MSEDCL supplies electricity to a total of 30.7 million consumers across the categories all over Maharashtra. There are about 22.93 million Domestic Residential (74.48%), 4.7 million Agricultural (15.4%), 2.2 million Commercial Consumers (7.33%), and 0.48 million Industrial consumers (1.56 %) in MSEDCL which fetch an Annual Revenue of about Rs. 1,16,817 Crs [Rs. 1,168 Billion] for FY2023-24.
The various DISCOMs in Maharashtra namely MSEDCL, Tata, Reliance and Torrent Power are expected to support net metering. As of now MSEDCL does not use the TOD (Time of The Day differential) charging tariffs for residential consumers and net metering. Export and import units are considered at par for calculating Net Units and bill amount.
As of May 2017, installation of a rooftop solar system costs an average of $20,000. In the past, it had been more expensive. [15] Utility Dive wrote, "For most people, adding a solar system on top of other bills and priorities is a luxury" and "rooftop solar companies by and large cater to the wealthier portions of the American population."
For example, when the sun is more than about 60° above the horizon (<30°) the solar intensity is about 1000 W/m 2 (from equation I.1 as shown in the above table), whereas when the sun is only 15° above the horizon (=75°) the solar intensity is still about 600 W/m 2 or 60% of its maximum level; and at only 5° above the horizon still 27% of ...
An attached sunspace, also sometimes called a solar room or solarium, is a type of isolated gain solar system with a glazed interior space or room that is part of or attached to a building but which can be completely closed off from the main occupied areas. It functions like an attached greenhouse that makes use of a combination of direct-gain ...
Panel generation factor (PGF) [1] is used while calculating the size of solar photovoltaic cells. It is a varying factor depending upon the climate of the site location (depending upon global geographic location). For example, in Thailand it is 3.43, in EU countries it is 2.93, etc. This factor is used in calculation of "Total Watt-Peak Rating ...