enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Pole building framing - Wikipedia

    en.wikipedia.org/wiki/Pole_building_framing

    Siding materials for a pole building are most commonly rolled-rib 29-gauge enameled steel cut to length in 32-or-36-inch (813 or 914 mm) widths attached using color-matched screws with rubber washers to seal the holes. However, any standard siding can be used, including T1-11, vinyl, lap siding, cedar and even brick.

  3. Siding - Wikipedia

    en.wikipedia.org/wiki/Siding

    Siding may refer to: Siding (construction), the outer covering or cladding of a house; Siding (rail), a track section; See also. All pages with titles containing siding

  4. Vermont South, Victoria - Wikipedia

    en.wikipedia.org/wiki/Vermont_South,_Victoria

    These had white-painted brickwork, archways and dark strained trim. [ 96 ] [ 97 ] [ 98 ] Builder Ronald H. Toll & Son had the " Toll Futuristic 72" at 421 Burwood Highway with an earthy, brown brick exterior with a low-pitched roof, floor-to-ceiling windows and cathedral ceilings with exposed Oregon panelling. [ 99 ]

  5. Siding (rail) - Wikipedia

    en.wikipedia.org/wiki/Siding_(rail)

    A team track is a small siding or spur track intended for the use of area merchants, manufacturers, farmers and other small businesses to personally load and unload products and merchandise, usually in smaller quantities. [9] The term "team" refers to the teams of horses or oxen delivering wagon-loads of freight transferred to or from railway ...

  6. Wilson Siding - Wikipedia

    en.wikipedia.org/wiki/Wilson_Siding

    Wilson Siding, also known as Wilson, [1] is a locality in southern Alberta, Canada within the Lethbridge County. [2] It is located at the intersection of Highway 4 and Highway 845 , approximately 13 km (8.1 mi) southeast of Lethbridge .

  7. Citroën 2CV - Wikipedia

    en.wikipedia.org/wiki/Citroën_2CV

    The suspension system, designed by Alphonse Forceau, used front leading arms and rear trailing arms, connected to eight torsion bars beneath the rear seat: a bar for the front axle, one for the rear axle, an intermediate bar for each side, and an overload bar for each side. The front axle was connected to its torsion bars by cable.