Search results
Results from the WOW.Com Content Network
Diagramatic operation of a thermal wheel Ljungström Air Preheater by Swedish engineer Fredrik Ljungström (1875–1964). A thermal wheel, also known as a rotary heat exchanger, or rotary air-to-air enthalpy wheel, energy recovery wheel, or heat recovery wheel, is a type of energy recovery heat exchanger positioned within the supply and exhaust air streams of air-handling units or rooftop ...
The desiccant absorbs moisture from the air leaving the cold surface, releasing heat and drying the air, which can be used in a process requiring dry air. The desiccant is then dried by an air stream at a lower relative humidity, where the desiccant gives up its moisture by evaporation, increasing the air's relative humidity and cooling it ...
There are two common types of dehumidifiers: condensate dehumidifiers and desiccant dehumidifiers, and there are also other emerging designs. Condensate dehumidifiers use a refrigeration cycle to collect water known as condensate, which is normally considered to be greywater but may at times be reused for industrial purposes.
Diagramatic operation of a thermal wheel Ljungström Air Preheater by Swedish engineer Fredrik Ljungström (1875–1964). A thermal wheel, also known as a rotary heat exchanger, or rotary air-to-air enthalpy wheel, energy recovery wheel, or heat recovery wheel, is a type of energy recovery heat exchanger positioned within the supply and exhaust air streams of air-handling units or rooftop ...
One measure of desiccant efficiency is the ratio (or percentage) of water storable in the desiccant relative to the mass of desiccant. Another measure is the residual relative humidity of the air or other fluid being dried. For drying gases, a desiccant's performance can be precisely described by the dew point of the dried product. [1]
Diagram of thermodynamic surface from Maxwell's book Theory of Heat.The diagram is drawn roughly from the same angle as the upper left photo above, and shows the 3D axes e (energy, increasing downwards), ϕ (entropy, increasing to the lower right and out-of-plane), and v (volume, increasing to the upper right and into-plane).
A heat engine is a system that performs the conversion of a flow of thermal energy (heat) to mechanical energy to perform mechanical work. [ 32 ] [ 33 ] A thermocouple is a temperature-measuring device and a widely used type of temperature sensor for measurement and control, and can also be used to convert heat into electric power.
In physics and engineering, heat flux or thermal flux, sometimes also referred to as heat flux density [1], heat-flow density or heat-flow rate intensity, is a flow of energy per unit area per unit time. Its SI units are watts per square metre (W/m 2). It has both a direction and a magnitude, and so it is a vector quantity.