Search results
Results from the WOW.Com Content Network
Debarker machine Manually decorticated trunk of a spruce as protection to bark beetles. Debarking is the process of removing bark from wood. Traditional debarking is conducted in order to create a fence post or fence stake which would then go on to be pointed before being planted. [1] Debarking can occur naturally during powerful tornadoes. [2]
A birch-bark roof (in Finnish: malkakatto or tuohikatto) is a roof construction traditional in Finland and Norway for farmhouses and farm buildings built from logs. The birch-bark roof was the prevailing roof type in rural Finland up until the 1860s, when it was replaced by the use of other materials such as metal sheeting and later roofing felt .
Section view through a house roof drawing showing names for parts of the structure. [clarification needed] (UK and Australia). Ctrs. means centers, a typical line to which carpenters layout framing. Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates. [1]
A hydraulic debarker is a machine removing bark from wooden logs by the use of water under a pressure of 700 kilopascals (100 pounds per square inch) or greater. [1] Hydraulic debarking can reduce soil and rock content of bark, but may increase the water content.
Only the heartwood and sapwood are useful for making pulp. Bark contains relatively few useful fibres and is removed and used as fuel to provide steam for use in the pulp mill. Most pulping processes require that the wood be chipped and screened to provide uniform sized chips. [citation needed]
A cruck or crook frame is a curved timber, one of a pair, which support the roof of a building, historically used in England and Wales. This type of timber framing consists of long, generally naturally curved, timber members that lean inwards and form the ridge of the roof. These posts are then generally secured by a horizontal beam which then ...
The same steps can be taken for joints D, H and E resulting in the complete Cremona diagram where the internal forces in all members are known. In a next phase the forces caused by wind must be considered. Wind will cause pressure on the upwind side of a roof (and truss) and suction on the downwind side. This will translate to asymmetrical ...
In Scandinavia shakes, traditionally used only for roofing, are generally smaller than in North America, measuring 13–16 inches (330–410 mm) long, 4–6 inches (100–150 mm) wide and 1 ⁄ 8 inch (3.2 mm) thick, [6] while in Poland and Slovakia they are usually 36 inches (910 mm) long, 4–6 inches (100–150 mm) wide and 1–1.25 inches ...