enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   The most common flare fitting standards in use today are the 45° SAE flare [2] [3],the 37° JIC flare, and the 37° AN flare. For high pressure, flare joints are made by doubling the tube wall material over itself before the bell end is formed. The double flare avoids stretching the cut end where a single flare may crack.

3. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   Mixing them can cause leakage at the flare. Note that AN threads are different for bolts and fittings. In bolts the number refers to the diameter of the bolt whereas in a fitting it refers to the OD of the tube and thereby have different threads. For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread ...

4. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   The left is the male part, the right is female. A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right. JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating ...

5. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Copper fittings for soldered joints Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...

6. National pipe thread - Wikipedia

   en.wikipedia.org/wiki/National_pipe_thread

   MIP is an abbreviation for male iron pipe, and FIP is an abbreviation for female iron pipe. [ 2 ] Outside North America, some US pipe thread sizes are widely used, as well as many British Standard Pipe threads and ISO 7–1, 7–2, 228–1, and 228-2 threads.

7. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   These sizing schemes allow for universal adaptation of transitional fittings. For instance, 1/2" PeX tubing is the same size as 1/2" copper tubing. 1/2" PVC on the other hand is not the same size as 1/2" tubing, and therefore requires either a threaded male or female adapter to connect them.