Search results
Results from the WOW.Com Content Network
When a system on a chip (SoC) enters suspend to RAM mode, in many cases, the processor is completely off while the RAM is put in self refresh mode. At resume, the boot ROM is executed again and many boot ROMs are able to detect that the SoC was in suspend to RAM and can resume by jumping directly to the kernel which then takes care of powering on again the peripherals which were off and ...
A bootloader, also spelled as boot loader [1] [2] or called bootstrap loader, is a computer program that is responsible for booting a computer and booting an operating system. If it also provides an interactive menu with multiple boot choices then it's often called a boot manager .
Note: The column MBR (Master Boot Record) refers to whether or not the boot loader can be stored in the first sector of a mass storage device. The column VBR (Volume Boot Record) refers to the ability of the boot loader to be stored in the first sector of any partition on a mass storage device.
The Android Bootloader (Aboot or ABL), which implements the fastboot interface. Android Bootloader verifies the authenticity of the boot and recovery partitions. [4] By pressing a specific key combination, devices can also boot in recovery mode. Android Bootloader then transfers control to the Linux kernel.
Then the boot loader loads the OS kernel from the storage device. If there is no active partition, or the active partition's boot sector is invalid, the MBR may load a secondary boot loader which will select a partition (often via user input) and load its boot sector, which usually loads the corresponding operating system kernel.
The boot loader on the option ROM would attempt to boot from a disk, network, or other boot program source attached to or installed on the adapter card; if that boot attempt failed, it would pass control to the previous boot loader (to which INT 19h pointed before the option ROM hooked it), allowing the system to boot from another device as a ...
The first stage bootloader, which is a part of the MBR, is a 512-byte image containing the vendor-specific program code and a partition table. [6] As mentioned earlier in the introduction part, the first stage bootloader will find and load the second stage bootloader. [6] It does this by searching in the partition table for an active partition. [6]
flashing lock/oem lock *** – locks an OEM unlocked bootloader. erase – erases a specific partition. reboot – reboots the device into either the main operating system, the system recovery partition or back into its boot loader. devices – displays a list of all devices (with the serial number) connected to the host computer.