Search results
Results from the WOW.Com Content Network
Surface-mount technology (SMT), originally called planar mounting, [1] is a method in which the electrical components are mounted directly onto the surface of a printed circuit board (PCB). [2] An electrical component mounted in this manner is referred to as a surface-mount device ( SMD ).
The general term is socket, but there are numerous common alternatives, including power point, [7] plug socket, [8] wall socket, [9] and wall plug. [10] Modern British sockets for domestic use are normally manufactured as single or double units with an integral face plate and are designed to fit standard mounting boxes.
The same timeline seems to apply in Europe, where mechanical escapements were used in clocks by that time. Up to the 15th century, clockwork was driven by water, weights, or other roundabout, relatively primitive means, but in 1430 a clock was presented to Philip the Good, Duke of Burgundy, that was driven by a spring. This became a standard ...
A synchronous electric clock does not contain a timekeeping oscillator such as a pendulum or balance wheel, but instead counts the oscillations of the AC utility current from its wall plug to keep time. It consists of a small AC synchronous motor, which turns the clock's hands through a reduction gear train. [9]
Clock in Grand Central Terminal on the information kiosk. The clock has four 24-inch (61 cm) dials and was made by the Self Winding Clock Company. It was installed in 1913. The Self Winding Clock Company (SWCC) was a major manufacturer of electromechanical clocks from 1886 until about 1970. [1]
BS 6312 431A plug, colloquially a British Telecom 4-wire male plug. British telephone sockets were introduced in their current plug and socket form on 19 November 1981 by British Telecom to allow subscribers to connect their own telephones.
An antique Telechron clock will usually come to life immediately (though sometimes noisily) when it is plugged in. [citation needed] Telechron motors are easily quieted and revived by carefully drilling 2 small holes that just puncture the surface, one on the large section, and one on the small section. A very light oil is injected, and then ...
The motor accelerates from slip speed to synchronous speed during an accelerating half cycle of the reluctance torque. [3] Single-phase synchronous motors such as in electric wall clocks can freely rotate in either direction, unlike a shaded-pole type. Costs are an important parameter for starters. [38]