Search results
Results from the WOW.Com Content Network
Not all central heating systems require purchased energy. A few buildings are served by local geothermal heat, using hot water or steam from a local well to provide building heat. Such areas are uncommon. A passive solar system requires no purchased fuel but needs to be carefully designed for the site.
Air lock problems often occur when one is trying to recommission a system after it has been deliberately (for servicing) or accidentally emptied. Take, for example, a central heating system using a circulating pump to pump water through radiators. When filling such a system, air is trapped in the radiators. This air has to be vented using screw ...
The back boiler is typically used with a gravity feed circuit to the hot water cylinder, with a vent or overflow to prevent excess pressure build up.It can also be connected to a series of radiators to provide central heating but usually requires an electrical pump to be fitted to circulate the hot water, some systems can use the gravity circuit to include radiators.
A flame detector is a sensor designed to detect and respond to the presence of a flame or fire, allowing flame detection.Responses to a detected flame depend on the installation, but can include sounding an alarm, deactivating a fuel line (such as a propane or a natural gas line), and activating a fire suppression system.
HVAC (Heating, Ventilation and Air Conditioning) equipment needs a control system to regulate the operation of a heating and/or air conditioning system. [1] Usually a sensing device is used to compare the actual state (e.g. temperature) with a target state. Then the control system draws a conclusion what action has to be taken (e.g. start the ...
However, researchers report several open problems in building automation security. [ 19 ] [ 20 ] On November 11, 2019, a 132-page security research paper was released titled "I Own Your Building (Management System)" by Gjoko Krstic and Sipke Mellema that addressed more than 100 vulnerabilities affecting various BMS and access control solutions ...
Upgrade to a faster, more secure version of a supported browser. It's free and it only takes a few moments:
A fire alarm annunciator panel is located where it is accessible to fire-fighting crews, such as at building entrances/exits. The annunciator panel will indicate the system status using lamps (or LEDs), an audible warning tone, and depending on the system technology, the exact location or approximate physical location of the source of a fire ...