enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Magnetic drilling machine - Wikipedia

   en.wikipedia.org/wiki/Magnetic_drilling_machine

   A morse taper 3 arbor equipped magnetic drill machine using taper shank drill bits. The arbor or chuck on a magnetic drill is attached to the motor. It is a type of clamp used to attach the core drills. There are mainly two types of chuck available for the magnetic drill, industrial arbor (manual tightening) and quick change drill chucks.

3. Countersink - Wikipedia

   en.wikipedia.org/wiki/Countersink

   In manufacturing, a countersink (symbol: ⌵) is a conical hole cut into a manufactured object, or the cutter used to cut such a hole. A common use is to allow the head of a countersunk bolt , screw or rivet , when placed in the hole, to sit flush with or below the surface of the surrounding material (by comparison, a counterbore makes a flat ...

4. Counterbore - Wikipedia

   en.wikipedia.org/wiki/Counterbore

   The smaller top item is an insert, the middle shows another three-fluted counterbore insert, assembled in the holder. The shank of this holder is a Morse taper, although there are other machine tapers that are used in the industry. The lower counterbore is designed to fit into a drill chuck, and being smaller, is economical to make as one piece.

5. Harbor Freight Tools - Wikipedia

   en.wikipedia.org/wiki/Harbor_Freight_Tools

   Harbor Freight Tools won a declassification of the class action; that is, the court found that all the individual situations were not similar enough to be judged as a single class, and that their claims would require an individual-by-individual inquiry, so the case could not be handled on a class basis.

6. Drilling - Wikipedia

   en.wikipedia.org/wiki/Drilling

   Drilling is a cutting process where a drill bit is spun to cut a hole of circular cross-section in solid materials. The drill bit is usually a rotary cutting tool, often multi-point. The bit is pressed against the work-piece and rotated at rates from hundreds to thousands of revolutions per minute.

7. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   While the above is a common use of center drill bits, it is a technically incorrect practice and should not be considered for production use. The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The ...