Search results
Results from the WOW.Com Content Network
Benchtop drill press (left) and floor-standing drill press (right) A drill press is a drilling machine suitable for quick and easy drilling of straight holes, countersinking or counterboring that are perpendicular to both directions of a table surface. In comparison, it is more difficult and less repeatable to drill perpendicularly with a hand ...
In 1919 the Pennimans filed an unfair trade lawsuit against Eames (Atlas Press Co. v. Eames), claiming rights over the trademark, patent and improved design. The case was argued in front of the Michigan Supreme Court, which ruled that Eames had to cease use of the trademark, but refusing the transfer of the improved press to the Atlas company. [3]
Drill pipe (#16) is a joint of hollow tubing used to connect the surface equipment to the bottom hole assembly (BHA) and acts as a conduit for the drilling fluid. In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe.
A stand (of drill pipe) is two or three joints of drill pipe connected and stood in the derrick vertically, usually while tripping pipe. A stand of collars is similar, only made up of collars and a collar head. The collar head is screwed into the collar to allow it to be picked up by the elevators.
A drill press Drill press (then called a boring machine) boring wooden reels for winding barbed wire, 1917. A drill press (also known as a pedestal drill, pillar drill, or bench drill) is a style of drill that may be mounted on a stand or bolted to the floor or workbench. Portable models are made, some including a magnetic base.
Any digital modulation scheme with a continuous phase can be used to impose the information on a carrier signal. The most widely used modulation scheme is continuous phase modulation. [10] When underbalanced drilling is used, mud pulse telemetry can become unusable. This is usually because, in order to reduce the equivalent density of the ...
Guide Pillar & Guide Bush : Used for alignment between top and bottom halves of the press tools. Bottom plate:It is used to hold bottom half of the press tool with press slide. Stripper plate: it is used to strip off the component from punches. Strip guides: It is used to guide the strip into the press tool to perform the operation. Press tool
Microdrilling refers to the drilling of holes less than 0.5 mm (0.020 in). Drilling of holes at this small diameter presents greater problems since coolant fed drills cannot be used and high spindle speeds are required. High spindle speeds that exceed 10,000 RPM also require the use of balanced tool holders.