Search results
Results from the WOW.Com Content Network
The label edge routers at the edges of an MPLS cloud map between the end-to-end identifier, such as an IP address, and a link-local label. At each MPLS hop, there is a forwarding table that tells the label-switched router which outgoing interface is to receive the MPLS packet, and what label to use when sending the packet out that interface.
In network topology, a cable modem is a network bridge that conforms to IEEE 802.1D for Ethernet networking (with some modifications). The cable modem bridges Ethernet frames between a customer LAN and the coax network. Technically, it is a modem because it must modulate data to transmit it over the cable network, and it must demodulate data ...
The last router in an LSP, which pops the label from the packet, is called an egress router. Routers in between, which need only swap labels, are called transit routers or label switch routers (LSRs). Note that LSPs are unidirectional; they enable a packet to be label switched through the MPLS network from one endpoint to another.
A router [a] is a computer and networking device that forwards data packets between computer networks, including internetworks such as the global Internet. [2] [3] [4] Routers perform the "traffic directing" functions on the Internet. A router is connected to two or more data lines from different IP networks.
Label Distribution Protocol (LDP) is a protocol in which routers capable of Multiprotocol Label Switching (MPLS) exchange label mapping information. Two routers with an established session are called LDP peers and the exchange of information is bi-directional.
Wireless router [2] An internet box integrating a SIM Card. A modem (e.g. DSL modem, cable modem) by itself provides none of the functions of a router. [3] It merely allows ATM or PPP or PPPoE traffic to be transmitted across telephone lines, cable wires, optical fibers, wireless radio frequencies, or other physical layers. [4]
"Cable router" has two basic meanings: Single Cable Router (SCR) - a down-conversion device for the radio data link. It converts RF signal from a satellite dish or TV antenna to the user-defined IF channel. Usually, many SCRs are connected to a single coaxial cable - each converting to a separate IF channel. The entire system referred to as ...
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router , and can connect multiple computers through multiple Ethernet ports or an integral wireless access point .