Ad
related to: pavement design calculator
Search results
Results from the WOW.Com Content Network
Granular base equivalency or granular base equivalence (GBE) is a measure of total pavement thickness. [1] [2] Since pavement is composed of multiple layers with different physical properties, its total thickness is measured by GBE. GBE translates the thickness of different road layers to a number using a set of coefficients.
The IRI is used in managing pavement assets, as well as sometimes in evaluating new construction to determine bonus/penalty payments for contractors or for identifying specific locations where repairs or improvements (e.g., grinding or resurfacing) are recommended.
The Aircraft Classification Number (ACN) – Pavement Classification Number (PCN) method is a standardized international airport pavement rating system promulgated by the ICAO in 1981. The method has been the official ICAO pavement rating system for pavements intended for aircraft of apron (ramp) mass greater than 5700 kg from 1981 to 2020. [1]
For rigid pavements, design the pavement to resist a standard flexural stress of 2.75 MPa at the bottom of the cement concrete layer according to the LEA design procedure Calculate the single wheel load with a tire pressure of 1.50 MPa that would require the same pavement structural cross-section, this is the Derived Single Wheel Load (DSWL)
A falling weight deflectometer (FWD) is a testing device used by civil engineers to evaluate the physical properties of pavement in highways, local roads, airport pavements, harbor areas, railway tracks and elsewhere. The data acquired from FWDs is primarily used to estimate pavement structural capacity, to facilitate overlay design or ...
The pavement condition index (PCI) is a numerical index between 0 and 100, which is used to indicate the general condition of a pavement section.The PCI is widely used in transportation civil engineering [1] and asset management, and many municipalities use it to measure the performance of their road infrastructure and their levels of service. [2]
Many other agencies have adopted the California pavement design method, and specify R-Value testing for subgrade soils and road aggregates. The test method states: The R-value of a material is determined when the material is in a state of saturation such that water will be exuded from the compacted test specimen when a 16.8 kN load (2.07 MPa ...
Structural road design aims to ensure the road is strong enough for the expected number of vehicles in a certain number of years. The input of a calculation is the number expected of vehicles (e.g. 10,000,000) divided in groups (e.g. trucks, vans, cars) and the number of years that the road has to function before the road structure has to be fully renewed (e.g. 20 years).
Ad
related to: pavement design calculator