Search results
Results from the WOW.Com Content Network
A substation is a part of an electrical generation, transmission, and distribution system. Substations transform voltage from high to low, or the reverse, or perform any of several other important functions. Between the generating station and consumer, electric power may flow through several substations at different voltage levels.
Most of the world uses 50 Hz 220 or 230 V single phase, or 400 V three-phase for residential and light industrial services. In this system, the primary distribution network supplies a few substations per area, and the 230 V / 400 V power from each substation is directly distributed to end users over a region of normally less than 1 km radius.
Pages in category "Electrical substations" The following 9 pages are in this category, out of 9 total. This list may not reflect recent changes. ...
Power-system automation is the act of automatically controlling the power system via instrumentation and control devices.Substation automation refers to using data from Intelligent electronic devices (IED), control and automation capabilities within the substation, and control commands from remote users to control power-system devices.
Step-down substation: these transformers lower the voltage coming from the transmission lines which can be used in industry or sent to a distribution substation. Distribution substation: these transform the voltage lower again for the distribution to end users. Aside from transformers, other major components or functions of substations include:
This page lists power stations in Ethiopia, both integrated with the national power grid but also isolated ones.Due to the quickly developing demand for electricity in Ethiopia, operational power plants are listed as well as those under construction and also proposed ones likely to be built within a number of years.
Current transformers, especially those intended for high voltage substation service, may have multiple taps on their secondary windings, providing several ratios in the same device. This can be done to allow for reduced inventory of spare units, or to allow for load growth in an installation.
Typically, switchgear in substations is located on both the high- and low-voltage sides of large power transformers. The switchgear on the low-voltage side of the transformers may be located in a building, with medium-voltage circuit breakers for distribution circuits, along with metering, control, and protection equipment.