Search results
Results from the WOW.Com Content Network
TCEP is often used as a reducing agent to break disulfide bonds within and between proteins as a preparatory step for gel electrophoresis.. Compared to the other two most common agents used for this purpose (dithiothreitol and β-mercaptoethanol), TCEP has the advantages of being odorless, a more powerful reducing agent, an irreversible reducing agent (in the sense that TCEP does not ...
The oil is dyed blue to make it easier to recognize in the gasoline. It appears black in this bottle because it is not diluted. Two-stroke oil (also referred to as two-cycle oil, 2-cycle oil, 2T oil, or 2-stroke oil) is a special type of motor oil intended for use in crankcase compression two-stroke engines, typical of small gasoline-powered ...
Used oil re-refining is the process of restoring used oil to new oil by removing chemical impurities, heavy metals and dirt. [2] Used industrial and automotive oil is recycled at re-refineries. The used oil is first tested to determine suitability for re-refining, after which it is dehydrated and the water distillate is treated before being ...
An oil pump, a vane or gear pump powered by the engine, pumps the oil throughout the engine, including the oil filter. Oil filters can be a full flow or bypass type. In the crankcase of a vehicle engine, motor oil lubricates rotating or sliding surfaces between the crankshaft journal bearings (main bearings and big-end bearings) and rods ...
Aerated oil protects engine components far less effectively. A dry-sump system minimizes oil aeration, and also de-aerates oil far more effectively by pumping it first into a remote reservoir. Increased engine power. In a wet-sump engine, oil slosh against spinning parts causes substantial viscous drag which creates parasitic power loss.
The engine efficiency is less than when the engine is operating at full throttle. One solution to this issue is to shift the load in a multi-cylinder engine from some of the cylinders (by deactivating them) to the remaining cylinders so that they may operate under higher individual loads and with correspondingly higher effective compression ratios.
SOHC design (for a 1973 Triumph Dolomite Sprint) . The oldest configuration of overhead camshaft engine is the single overhead camshaft (SOHC) design. [1] A SOHC engine has one camshaft per bank of cylinders, therefore a straight engine has a total of one camshaft and a V engine or flat engine has a total of two camshafts (one for each cylinder bank).
The oil pump forces the motor oil through the passages in the engine to properly distribute oil to different engine components. In a common oiling system, oil is drawn out of the oil sump (oil pan, in US English) through a wire mesh strainer that removes some of the larger pieces of debris from the oil.