Ads
related to: jeep rear end identification 3707306 parts breakdown catalogquadratec.com has been visited by 10K+ users in the past month
carparts.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
Dana differential case #706400 [3] (3.07-3.73) shows in Dana's parts catalog to be Dana 61-specific [citation needed]. The 706040x carrier can be purchased relatively inexpensively and used to install lower gears in a Dana 61 axle, such as when replacing a broken or damaged Dana 60 with a Dana 61 while retaining the factory gear ratio.
Up to serial no. 13453, the MB-style full floating rear axle was fitted. Once they were used up, the CJ got a stronger Dana / Spicer model 41. [17] Sometimes the use of MB parts was due to strikes at suppliers, such as Autolite. Since Willys produced few parts in-house and relied heavily on suppliers, it was vulnerable to strikes.
The first new Jeep to feature an independent suspension since the 1963 Wagoneer, the Liberty (as it is known in North America; it goes by the name Cherokee in all other markets) replaced the XJ Cherokee in 2002. The Liberty comes with a 3.7 liter V6 engine, but was also available in the US in 2005–2006 with a 2.8L 4cylinder common rail diesel ...
Stock Jeep clocking for the Dana 300 (1980–1986) is usually 23° and stock Eagle and Jeep/New Process clocking is usually 13°. Many factors, most notably ground clearance and front drive shaft clearance, can necessitate a change in the clocking angle. Some aftermarket adapters feature flanges with multiple clocking options.
Available as a two-door Wrangler or four-door Wrangler Unlimited, the Rubicon X is a version of Rubicon with electronic-locking front and rear Dana 44 axles, Rock-Trac transfer case with a "4-Low" ratio of 4:1, 4.10 front/rear axle ratio Tru-Lok locking differentials, six-speed manual transmission, BF Goodrich KM 255/75R17 tires, 17-inch ...
Identification between the two can be made by examining the hub: the protrusion of the hub through the center of the wheel denotes the preferred 10.5-inch full-floating rear axle. While the 9.5-inch rear end exhibits its own durability, it is generally considered less favorable for high-torque applications.
Ads
related to: jeep rear end identification 3707306 parts breakdown catalogquadratec.com has been visited by 10K+ users in the past month
carparts.com has been visited by 100K+ users in the past month