enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Valve guide - Wikipedia

   en.wikipedia.org/wiki/Valve_guide

   The upper part of the valve stem, within the rocker box, is lubricated by oil. If this oil travels unchecked along the valve stem, engine HC emissions will become excessive. To control this, an elastomeric seal is fitted over the top of the valve guide. These may wear or stiffen with age, so are usually replaced whenever valves are removed for ...

3. Hydrolock - Wikipedia

   en.wikipedia.org/wiki/Hydrolock

   In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.

4. Valve job - Wikipedia

   en.wikipedia.org/wiki/Valve_job

   A valve job is the colloquial term for resurfacing the mating surfaces of the poppet valves and their respective valve seats that control the intake and exhaust of the air/fuel mixture in four stroke internal combustion engine, replacing valve oil seals, replacing any deficient valve springs, and otherwise bringing the components of a cylinder head up to manufacturer’s spec. [1] A ...

5. Poppet valve - Wikipedia

   en.wikipedia.org/wiki/Poppet_valve

   The location of the valves is broadly the same between OHV and OHC engines, however OHC engines saw the camshaft located to the top of the engine with the valves and OHC engines often have more valves per cylinder. Most OHC engines have an extra intake and an extra exhaust valve per cylinder (four-valve cylinder head), compared with the design ...

6. Steam dome - Wikipedia

   en.wikipedia.org/wiki/Steam_dome

   The passages of the steam jacket were large enough that the safety valve could also be mounted on the cylinder block. The regulator could also conveniently be built into the casting, immediately between the dome passage and the valve chest, without requiring long steam pipes. US traction engines were commonly fitted with domes, as were the ...

7. Valve timing - Wikipedia

   en.wikipedia.org/wiki/Valve_timing

   With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in drawing in the fresh charge. Engine designers ...