Search results
Results from the WOW.Com Content Network
10.16 cm = 1.016 dm – 1 hand used in measuring height of horses (4 inches) 12 cm = 1.2 dm – diameter of a compact disc (CD) (= 120 mm) 15 cm = 1.5 dm – length of a Bic pen with cap on; 22 cm = 2.2 dm – diameter of a typical association football (soccer ball) 30 cm = 3 dm – typical school-use ruler length (= 300 mm)
A ruler with two linear scales: the metric and imperial.It includes shorter minor graduations and longer major graduations. A graduation is a marking used to indicate points on a visual scale, which can be present on a container, a measuring device, or the axes of a line plot, usually one of many along a line or curve, each in the form of short line segments perpendicular to the line or curve.
A ruler, depicting two customary units of length, the centimeter and the inch A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units , used in every country globally.
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
After 1066, 1 inch was equal to 3 barleycorns, which continued to be its legal definition for several centuries, with the barleycorn being the base unit. [22] One of the earliest such definitions is that of 1324, where the legal definition of the inch was set out in a statute of Edward II of England , defining it as "three grains of barley ...
On a metric ruler, the smallest measurements are normally millimetres. [3] High-quality engineering rulers may be graduated in increments of 0.5 mm. Digital callipers are commonly capable of reading increments as small as 0.01 mm. [4] Microwaves with a frequency of 300 GHz have a wavelength of 1
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
For example, if a ruler's smallest mark is 0.1 cm, and 4.5 cm is read, then it is 4.5 (±0.1 cm) or 4.4 cm to 4.6 cm as to the smallest mark interval. However, in practice a measurement can usually be estimated by eye to closer than the interval between the ruler's smallest mark, e.g. in the above case it might be estimated as between 4.51 cm ...