Search results
Results from the WOW.Com Content Network
A cooling bath or ice bath, in laboratory chemistry practice, is a liquid mixture which is used to maintain low temperatures, typically between 13 °C and −196 °C. These low temperatures are used to collect liquids after distillation , to remove solvents using a rotary evaporator , or to perform a chemical reaction below room temperature ...
A common fixed-point calibration method for industrial-grade probes is the ice bath. The equipment is inexpensive, easy to use, and can accommodate several sensors at once. The ice point is designated as a secondary standard because its accuracy is ±0.005 °C (±0.009 °F), compared to ±0.001 °C (±0.0018 °F) for primary fixed points.
A thermometer has two important elements: (1) a temperature sensor (e.g. the bulb of a mercury-in-glass thermometer or the pyrometric sensor in an infrared thermometer) in which some change occurs with a change in temperature; and (2) some means of converting this change into a numerical value (e.g. the visible scale that is marked on a mercury ...
In sports therapy, an ice bath, or sometimes cold-water immersion, Cold plunge or cold therapy, is a training regimen usually following a period of intense exercise [1] [2] in which a substantial part of a human body is immersed in a bath of ice or ice-water for a limited duration.
The distinction of Celsius was to use the condition of melting and not that of freezing. The experiments for reaching a good calibration of his thermometer lasted for 2 winters. By performing the same experiment over and over again, he discovered that ice always melted at the same calibration mark on the thermometer.
The vapor is then cooled as it goes through the inner tube of the condenser. There it becomes liquid again, and drips into the smaller collecting flask at right, immersed in a cooling bath. The two hoses connected to the condenser circulate water through the space between the inner and outer walls.
The Siwoloboff method is used to determine the boiling point of small samples of liquid chemicals. A sample in an ignition tube (also called a fusion tube) is attached to a thermometer with a rubber band, and immersed in a Thiele tube, water bath, or other suitable medium for heating. A sealed capillary, open end pointing down, is placed in the ...
First, the thermometer is inverted and gently tapped so that the mercury in the reservoir lodges in the bend (B) at the end of the stem. Next, the bulb is heated until the mercury in the stem joins the mercury in the reservoir. The thermometer is then placed in a bath one or two degrees above the upper limit of temperatures to be measured.