Search results
Results from the WOW.Com Content Network
Transistor testers have the necessary controls and switches for making the proper voltage, current and signal settings. A meter with a calibrated "good" and "bad" scale is on the front. In addition, these transistor testers are designed to check the solid-state diodes. There are also testers for checking high transistor and rectifiers.
A curve tracer is a specialised piece of electronic test equipment used to analyze the characteristics of discrete electronic components, such as diodes, transistors, thyristors, and vacuum tubes. The device contains voltage and current sources that can be used to stimulate the device under test (DUT).
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
In electrical engineering, an electrical isolation test is a direct current (DC) or alternating current (AC) resistance test that is performed on sub-systems of an electronic system to verify that a specified level of isolation resistance is met. Isolation testing may also be conducted between one or more electrical circuits of the same ...
A view of the LTZ1000 voltage reference onboard the Keysight 34470A multimeter. The LTZ1000 is a high-precision, ultra-stable Zener diode voltage reference originally developed by Carl Nelson for Linear Technology (now Analog Devices). It consists of a Zener reference packaged along with an integrated heater and temperature sensor designed to ...
Wafer testing is a step performed during semiconductor device fabrication after back end of line (BEOL) and before IC packaging.. Two types of testing are typically done. Very basic wafer parametric tests (WPT) are performed at a few locations on each wafer to ensure the wafer fabrication process has been carried out successfully.
A test setup suitable for testing receivers at microwave frequencies is shown in the figure. The two signal generators, F1 and F2, are combined using a directional coupler in reverse. That is, the two generators are connected to what would normally be the coupled and transmitted output ports respectively.
Instrumentation embedded into chips (embedded instrumentation) is employed in a variety of electronic test applications, including validating and testing chips themselves, validating, testing and debugging the circuit boards where these chips are deployed, and troubleshooting systems once they have been installed in the field.