Search results
Results from the WOW.Com Content Network
The most well known analog simulator is SPICE. Probably the best known digital simulators are those based on Verilog and VHDL . Some electronics simulators integrate a schematic editor , a simulation engine, and an on-screen waveform display (see Figure 1), allowing designers to rapidly modify a simulated circuit and see what effect the changes ...
A simple modification of the previous schematic replaces the LED with three components to create a simple zener diode based voltage regulator. Diode D1 acts as a half-wave rectifier to allow capacitor C to charge up only when a higher voltage is available from the joule thief on the left side of diode D1. The Zener diode D2 limits the output ...
Ideal diode with constant voltage drop when closed, and zero current when open Ideal amplifier with zero output resistance, infinite gain, and infinite bandwidth Non-linear components are represented as piecewise-linear , or as a function (simulated with one step delay).
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
LTspice is a SPICE-based analog electronic circuit simulator computer software, produced by semiconductor manufacturer Analog Devices (originally by Linear Technology). [2] It is the most widely distributed and used SPICE software in the industry. [6]
The real diode now can be replaced with the combined ideal diode, voltage source and resistor and the circuit then is modelled using just linear elements. If the sloped-line segment is tangent to the real diode curve at the Q-point, this approximate circuit has the same small-signal circuit at the Q-point as the real diode.
Normally, both are charged from a single alternator, and a heavy-duty split-charge diode is used to prevent the higher-charge battery (typically the engine battery) from discharging through the lower-charge battery when the alternator is not running. Diodes are also used in electronic musical keyboards.
The DIAC (diode for alternating current) is a diode that conducts electrical current only after its breakover voltage, V BO, has been reached momentarily. Three, four, and five layer structures may be used. [1] Behavior is similar to the voltage breakdown of a triac without a gate terminal.