enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Sandpaper - Wikipedia

   en.wikipedia.org/wiki/Sandpaper

   The grit size of sandpaper is usually stated as a number that is inversely related to the particle size. A small number such as 20 or 40 indicates a coarse grit, while a large number such as 1500 indicates a fine grit.

3. French polish - Wikipedia

   en.wikipedia.org/wiki/French_polish

   The piece is usually finished off after leveling (1500 grit oil sanding), then light buffing with carnauba paste wax. Too much heat or pressure from buffing will melt off the shellac and result in a bare spot that must be refinished. [3]

4. Floor sanding - Wikipedia

   en.wikipedia.org/wiki/Floor_sanding

   The best method when using a drum sander is to start out with a lower grit belt sandpaper. For oak, maple, and ash hardwoods, It is recommended to start with 40 grit, then with each subsequent sanding pass, go up in sandpaper grit e.g. 60, 80, and finish with 100 grit. When wood floor planks are warped, cupped, or significantly uneven, it may ...

5. Grit - Wikipedia

   en.wikipedia.org/wiki/Grit

   Grit, one of the byproducts of grinding, an abrasive machining process; Grit removal, the removal of grit, the coarse abrasive material in untreated sewage; Grit size table, fineness/coarseness classification of sandpaper grit, and compares the CAMI and "P" designations with the average grit size in micrometres (μm)

6. Polished concrete - Wikipedia

   en.wikipedia.org/wiki/Polished_concrete

   The polishing process begins with a 50-grit diamond resin pad instead of a metal segment. When using the resin pads the steps may be 100, then 200, 400, 800, 1600 and finally 3000+ grit. Throughout the process, a densifier is used to harden the concrete surface, which allows the concrete to be polished.

7. Steel abrasive - Wikipedia

   en.wikipedia.org/wiki/Steel_abrasive

   Surface preparation is a series of operations including cleaning and physical modification of a surface. Steel shot and grit are used in a surface preparation process for cleaning metal surfaces which are covered with mill scale, dirt, rust, or paint coatings and for physically modifying the metal surface such as creating roughness for better application of paint and coating.