Search results
Results from the WOW.Com Content Network
The electric field is defined as a vector field that associates to each point in space the force per unit of charge exerted on an infinitesimal test charge at rest at that point. [2] [3] [4] The SI unit for the electric field is the volt per meter (V/m), which is equal to the newton per coulomb (N/C). [5]
electric flux: volt metre: V⋅m kg⋅m 3 ⋅s −3 ⋅A −1: E electric field strength volt per metre: V/m = N/C kg⋅m⋅A −1 ⋅s −3: D electric displacement field: coulomb per square metre: C/m 2: A⋅s⋅m −2: ε permittivity: farad per metre: F/m kg −1 ⋅m −3 ⋅A 2 ⋅s 4: χ e electric susceptibility (dimensionless) 1 1 p ...
Energy required to move a unit charge through an electric field from a reference point volt (V = J/C) L 2 M T −3 I −1: extensive, scalar Electrical resistance: R: Electric potential per unit electric current ohm (Ω = V/A) L 2 M T −3 I −2: extensive, scalar, assumes linearity Electrical resistivity: ρ e: Bulk property equivalent of ...
The electric field strength at a specific point can be determined from the power delivered to the transmitting antenna, its geometry and radiation resistance. Consider the case of a center-fed half-wave dipole antenna in free space, where the total length L is equal to one half wavelength (λ/2).
The field strength at which break down occurs is an intrinsic property of the material called its dielectric strength. In practical electric circuits electrical breakdown is often an unwanted occurrence, a failure of insulating material causing a short circuit , resulting in a catastrophic failure of the equipment.
E = the RMS electric field strength in volts per meter, H = the RMS magnetic field strength in amperes per meter. [6] The above equation yields units of W/m 2. In the USA the units of mW/cm 2, are more often used when making surveys. One mW/cm 2 is the same power density as 10 W/m 2. The following equation can be used to obtain these units ...
In physics, field strength is the magnitude of a vector-valued field (e.g., in volts per meter, V/m, for an electric field E). [1] For example, an electromagnetic field has both electric field strength and magnetic field strength .
The fourth unit could be chosen to be electric current, voltage, or electrical resistance. [35] Electric current with named unit 'ampere' was chosen as the base unit, and the other electrical quantities derived from it according to the laws of physics. When combined with the MKS the new system, known as MKSA, was approved in 1946. [4]