Search results
Results from the WOW.Com Content Network
The pressure vessels can be either fired or unfired. [17] The pressure may be from external sources, or by the application of heating from an indirect or direct source as a result of a process, or any combination of the two. [18] The rules contained in this section can be used as an alternative to the minimum requirements specified in Division 1.
Stanley steam-car boiler: an extremely compact vertical multitubular fire-tube boiler, used in the Stanley steam car. Steam generator: modern boilers, with very small volume in relation to their heating area. Boiling is thus almost instantaneous and the volume of heated, but unboiled, water is minimal. [56]
The ASME definition of a pressure vessel is a container designed to hold gases or liquids at a pressure substantially different from the ambient pressure. [2]The Australian and New Zealand standard "AS/NZS 1200:2000 Pressure equipment" defines a pressure vessel as a vessel subject to internal or external pressure, including connected components and accessories up to the connection to external ...
Piping and instrumentation diagram of pump with storage tank. Symbols according to EN ISO 10628 and EN 62424. A more complex example of a P&ID. A piping and instrumentation diagram (P&ID) is defined as follows: A diagram which shows the interconnection of process equipment and the instrumentation used to control the process.
Energy recovery systems with regenerative suspension and regenerative braking produce low pressure compressed air. This can be stored in a pressure vessel. Pistonless engines using compressed air are very quiet. [11] There is no fire hazard after accidents, unlike systems that utilize combustion fuels or high power batteries.
The immersion fired boiler is a single-pass fire-tube boiler that was developed by Sellers Engineering in the 1940s. It has only firetubes, functioning as a furnace and combustion chamber also, with multiple burner nozzles injecting premixed air and natural gas under pressure.
The low-pressure systems—as used on the 1992 Aprilia SR50 motor scooter—uses a crankshaft-driven air compressor to inject air into the cylinder head. A low-pressure injector then sprays fuel into the combustion chamber, where it vaporizes as it mixes with the compressed air.
Free-piston engine used as a gas generator to drive a turbine. A free-piston engine is a linear, 'crankless' internal combustion engine, in which the piston motion is not controlled by a crankshaft but determined by the interaction of forces from the combustion chamber gases, a rebound device (e.g., a piston in a closed cylinder) and a load device (e.g. a gas compressor or a linear alternator).