Search results
Results from the WOW.Com Content Network
The H1 lamp uses a P14.5s base in accord with IEC 60061. [1] This is a round metal prefocus base 14.5 mm in diameter with a flat and two dimples so the H1 can be installed in a lamp only in the one correct orientation. There is one 6.35 mm male spade terminal in the center of the base, through which power is supplied.
Bulbs used for headlamps, turn signals and brake lamps may be required to comply with international and national regulations governing the types of lamps used. Other automotive lighting applications such as auxiliary lamps or interior lighting may not be regulated, but common types are used by many automotive manufacturers.
To reduce unintentional ultraviolet (UV) exposure, and to contain hot bulb fragments in the event of explosive bulb failure, general-purpose lamps usually have a UV-absorbing glass filter over or around the bulb. Alternatively, lamp bulbs may be doped or coated to filter out the UV radiation. With adequate filtering, a halogen lamp exposes ...
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
Fluorescent lamps in various embodiments. Since their introduction as a commercial product in 1939, many different types of fluorescent lamp have been introduced. Systematic nomenclature identifies mass-market lamps as to overall shape, power rating, length, color, and other electrical and illuminating characteristics.
[[Category:Billboard chart templates]] to the <includeonly> section at the bottom of that page. Otherwise, add <noinclude>[[Category:Billboard chart templates]]</noinclude> to the end of the template code, making sure it starts on the same line as the code's last character.
The most commonly used A-series light bulb type is an A60 bulb [7] (or its inch-based equivalent, the A19 bulb [2] [4]), which is 60 mm (19 ⁄ 8 in or 2 + 3 ⁄ 8 in) wide at its widest point [3] and approximately 110 mm (4 + 3 ⁄ 8 in) in length. [8] Other sizes with a data sheet in IEC 60064 are A50, A55, A67, A68, A71, A75, and A80.
A sticker that is half-red and half-white indicates a pulse start metal halide lamp (PSMH). Green is also used on HPS units in Canada. Gray indicates that the fixture is of an LED type. In addition to being colour-coded, newer NEMA stickers also state the lamp type abbreviation just below the lamp's wattage (e.g. HPS, LED).