Search results
Results from the WOW.Com Content Network
TRIAC. For other uses, see Triac. A TRIAC (triode for alternating current; also bidirectional triode thyristor or bilateral triode thyristor[ 1 ]) is a three-terminal electronic component that conducts current in either direction when triggered. The term TRIAC is a genericised trademark. TRIACs are a subset of thyristors (analogous to a relay ...
The thyristor is a four-layered, three-terminal semiconductor device, with each layer consisting of alternating N-type or P-type material, for example P-N-P-N. The main terminals, labelled anode and cathode, are across all four layers. The control terminal, called the gate, is attached to p-type material near the cathode.
A Voltage controller thyristor based dimmer rack An electrical schematic for a typical SCR-based light dimmer. A voltage controller, also called an AC voltage controller or AC regulator is an electronic module based on either thyristors, triodes for alternating current, silicon-controlled rectifiers or insulated-gate bipolar transistors, which converts a fixed voltage, fixed frequency ...
A silicon controlled rectifier or semiconductor controlled rectifier is a four-layer solid-state current -controlling device. The name "silicon controlled rectifier" is General Electric 's trade name for a type of thyristor. The principle of four-layer p–n–p–n switching was developed by Moll, Tanenbaum, Goldey, and Holonyak of Bell ...
Phase-fired control (PFC) is often used to control the amount of voltage, current or power that a power supply feeds to its load. It does this to create an average value at its output. If the supply has a DC output, its time base is of no importance in deciding when to pulse the supply on or off, as the value that will be pulsed on and off is ...
A thyratron is a type of gas-filled tube used as a high-power electrical switch and controlled rectifier. Thyratrons can handle much greater currents than similar hard-vacuum tubes. Electron multiplication occurs when the gas becomes ionized, producing a phenomenon known as a Townsend discharge. Gases used include mercury vapor, xenon, neon ...
References. 0-10 V lighting control. 0–10 V is one of the first and simplest electronic lighting control signaling systems, used as an early fluorescent dimming system. [ 1 ] Simply put, the control signal is a DC voltage that varies between zero and ten volts. Two standards are recognized: current sourcing and current sinking.
The difference between "Plummer’s device" and "Becke’s device" is that "Plummer’s device" has the mode of thyristor action in its operation range, but "Becke’s device" never has the mode of thyristor action in its entire operation range. This is a critical point, because the thyristor action is the same as so-called "latch-up".