Search results
Results from the WOW.Com Content Network
The king post is the central, vertical member of the truss. Crown posts in the nave roof at Old Romney church, Kent, England. A king post (or king-post or kingpost) is a central vertical post used in architectural or bridge designs, working in tension to support a beam below from a truss apex above (whereas a crown post, though visually similar, supports items above from the beam below).
Scarf joint. The scarf joint used on the beams above the post is known by its French name, trait de jupiter, or bolt-o-lightning joint. A scarf joint, or scarph joint, is a method of joining two members end to end in woodworking or metalworking. [1] The scarf joint is used when the material being joined is not available in the length required.
[6] [a] Sometimes a Palladian truss is defined as a compound truss with a queen post and king post truss in the same assembly. [7] The queen post truss and the king post truss may be combined, by using the straining beam of the queen post truss as the tie beam for a king post truss above. [8] Such combinations are known as compound trusses.
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles. In most automobiles, beam axles have been ...
Pole framing or post-frame construction[1] (pole building framing, pole building, pole barn) is a simplified building technique that is an alternative to the labor-intensive traditional timber framing technique. It uses large poles or posts buried in the ground or on a foundation to provide the vertical structural support, along with girts to ...
Welding, bolts, or rivets. v. t. e. In structural engineering and construction, a gusset plate is a plate for connecting beams and girders to columns. A gusset plate can be fastened to a permanent member either by bolts, rivets or welding or a combination of the three. [1] They are used in bridges and buildings, as well as other structures.
Portal frames can be defined as two-dimensional rigid frames that have the basic characteristics of a rigid joint between column and beam. The main objective of this form of design is to reduce bending moment in the beam, which allows the frame to act as one structural unit. The transfer of stresses from the beam to the column results in ...
A girder bridge is a bridge that uses girders as the means of supporting its deck. [1] The two most common types of modern steel girder bridges are plate and box. [citation needed] The term "girder" is often used interchangeably with "beam" in reference to bridge design. [2][3][4][5] However, some authors define beam bridges slightly ...